JYQD-V7.3E2 Brushless Motor Driver Board , 12V - 36V DC Bldc Motor Driver Control 

2V,24V,36V,5A,10A,15A 500W brushless DC motor driver,Hall sensor,brushless DC motor speed controller

JYQD-V7.3E2 12V-36V brushless DC motor driver circuit board


ATTENTION:

1: This brushless DC motor driver board is widely apply to DC Brushless with Hall sensor (120°angle) three-wire motors
2:please make sure to add heat sink when the output power more than 60W.

 
When installing the heat sink, please add insulation layer for 6pcs MOS. It will damage the driver board permanently without insulation,and also apply Heat-Conducting Silicone Grease on the insulation for better cooling.

3: As the BLDC motor factory may use different Hall sequence,if the motor start abnormal, can't start or the current getting to high, please adjust the sequence of the Hall, or the driver will be damaged.

 

4:Please offer the right voltage to the driver, do not exceed the operating range. and the driver has built-in 5V for speed control, DO NOT connect extra power supply( 5V ) into the driver for speed controlling, it will damage the driver.

 

Specifications

Operating Voltage DC 12V-36V
Operating current ≤15A
Output power ≤500W
Speed control 0.1V-5V or PWM input
Operating temperature -40-85℃
Operating humidity ≤90%
Protection Overload protection, locked-rotor protection, over-current protection
Functions Speed pulse signal output, soft reversing (485,CAN port optional)
Overall dimension 63X42.5X17mm (L*W*H)
Net weight 30g
Optional component

Speed regulating potentiometer

external 5 digit tachometer

 

 

Wiring instructions

JYQD-V7.3E2 Brushless Motor Driver Board , 12V - 36V DC Bldc Motor Driver Control 

 

 

 

 

Mounting dimension

JYQD-V7.3E2 Brushless Motor Driver Board , 12V - 36V DC Bldc Motor Driver Control 

 

Products

Brushless DC Motor Driver

Call Us
Contact Supplier
Change Language